INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY
(a) Apply a light coat of lithium soap base glycol grease to a new O-ring.
(b) Install the O-ring to the rear disc brake cylinder assembly.
NOTICE:
Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.
(c) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.
Torque:
for TMC Made :
8.4 N·m {86 kgf·cm, 74 in·lbf}
for TMMT Made :
11 N·m {112 kgf·cm, 8 ft·lbf}
2. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
(a) Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.
3. INSTALL REAR WHEEL
Click here
Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Top-mounted
Air Conditioner Pressure Sensor): Compressor Solenoid Circuit (B1451)
DESCRIPTION
In this circuit, the compressor with pulley assembly (compressor solenoid) receives
a refrigerant compression demand signal from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly (compressor solenoid)
changes the amount of compressor ...
Toyota CH-R Service Manual > Fuel Lid Opener Switch: Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM BOARD LH
Click here
3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
5. REMOVE INSTRUM ...