Toyota CH-R Service Manual: HD Radio Tuner Malfunction (B1551,B158D,B15B0,B15B3,B15B7,B15BA)

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

  Click here

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly may not operate normally.

Voice Recognition Microphone Disconnected (B1579)

DESCRIPTION The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines. Thi ...

Extension Module Malfunction 2 (B1556)

DESCRIPTION These DTCs are stored when a malfunction occurs in the Navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area ...

Other materials:

Toyota CH-R Service Manual > Washer Motor: Installation
INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Install the washer motor and pump assembly as shown in the illustration. Install in this Direction (b) Connect the connector. (c) Connect the washer hose. 2. ADD WASHER FLUID (a) Co ...

Toyota CH-R Service Manual > Vehicle Stability Control System: Zero Point Calibration of Acceleration Sensor Undone (C1336)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 circu ...