DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Navigation System > Data List
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
Battery Voltage |
Battery voltage |
Min.: 0 V, Max.: 24 V |
11 to 14 V |
- |
Active Dimmer |
Active dimmer function |
ON or OFF |
ON: Active dimmer function on OFF: Active dimmer function off |
- |
Tail Light SW |
Taillight switch |
ON or OFF |
ON: Light control switch in tail or head position OFF: Light control switch off or AUTO |
- |
Reverse Signal |
Reverse signal |
ON or OFF |
ON: Shift lever in R OFF: Shift lever not in R |
- |
Parking Brake |
Parking brake switch |
ON or OFF |
ON: Parking brake applied OFF: Parking brake released |
- |
Ignition |
Engine switch |
ON or OFF |
ON: Engine switch on (IG) OFF: Engine switch off or on (ACC) |
"OFF" is displayed even though the engine switch is on (ACC) |
Vehicle Speed |
Maximum wheel speed sensor reading |
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) |
Vehicle stopped: 0 km/h (0 mph) |
When driving at constant speed: No large fluctuations |
HDMI Line(Blu-ray Disc Player) |
- |
Disconnected or Connected |
Disconnected |
Not available |
Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted
Air Conditioner Pressure Sensor): Initialization
INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Press the A/C OFF switch.
(e) Turn the Techstream on.
(f) Enter the following menus: Body Electrical / Air Conditioner / Utility /
Serv ...
Toyota CH-R Service Manual > Front Evaporator Temperature Sensor(for Denso Made): Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 COOLER THERMISTOR
(a) Install the No. 1 cooler thermistor as shown in the illustration.
Installation Position:
Part
Length
A
50.0 mm (1.97 in.)
...