Toyota CH-R Service Manual: Lost Communication with Body Control Module "B" (U0142,U0155,U0163)

Toyota CH-R Service Manual / Cellular Communication / Toyota Entune System / Lost Communication with Body Control Module "B" (U0142,U0155,U0163)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the CAN communication circuit.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0142

Lost Communication with Body Control Module "B"

Lost communication with main body ECU (multiplex network body ECU)

CAN communication system

U0155

Lost Communication with Instrument Panel Cluster (IPC) Control Module

Lost communication with combination meter assembly

CAN communication system

U0163

Lost Communication with Navigation Control Module

Lost communication with radio and display receiver assembly

CAN communication system

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here

Body Electrical > Telematics > Clear DTCs

(b) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Telematics > Trouble Codes

Result

Proceed to

DTCs are output.

A

DTCs are not output.

B

HINT:

  • If CAN communication system DTCs are stored, they may also be stored for other systems.
  • If the CAN communication system has been inspected and repaired, these DTCs will not be output when rechecking for DTCs.
  • If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.

    Click here

A

GO TO CAN COMMUNICATION SYSTEM

B

USE SIMULATION METHOD TO CHECK

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / T ...

    GPS Mark is not Displayed
    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Open in Bus 4 Main Bus Line
    DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 22 (CA2H) and 7 (CA2L) of the central gateway ECU (network gateway ECU) is 70 Ω or higher. Symptom Trouble Area Resistance between terminals 2 ...

    Toyota CH-R Service Manual > Lighting System: ACC Signal Circuit
    DESCRIPTION This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU (multiplex network body ECU). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedu ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0112