INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. INSTALL REAR SEAT CUSHION LOCK HOOK
(a) Engage the claws to install a new rear seat cushion lock hook as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
Install in this Direction |
2. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
(a) Place the bench type rear seat cushion assembly in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
(b) Engage the rear seat cushion frame hook on the rear side of the bench type rear seat cushion assembly as shown in the illustration.
*a |
Rear Seat Cushion Frame Hook Front Side |
*b |
Rear Seat Cushion Frame Hook Rear Side |
Install in this Direction (1) |
|
Install in this Direction (2) |
(c) Engage the rear seat cushion frame hooks on the front side of the bench type rear seat cushion assembly as shown in the illustration.
NOTICE:
Confirm that the bench type rear seat cushion assembly is securely installed.
3. INSTALL REAR SEATBACK ASSEMBLY LH
(a) Place the rear seatback assembly LH in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
(b) Engage the guides to install the rear seatback assembly LH. |
|
(c) Install the 2 bolts.
Torque:
36.8 N·m {375 kgf·cm, 27 ft·lbf}
NOTICE:
Tighten bolts in the order shown in the illustration.
(d) Engage the hook and loop fasteners. |
|
(e) Pull back the rear seatback assembly LH.
4. INSTALL REAR SEATBACK ASSEMBLY RH
(a) Place the rear seatback assembly RH in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
(b) Engage the guides to install the rear seatback assembly RH. |
|
(c) Install the 2 bolts.
Torque:
36.8 N·m {375 kgf·cm, 27 ft·lbf}
NOTICE:
Tighten bolts in the order shown in the illustration.
(d) Engage the hook and loop fasteners. |
|
(e) Pull back the rear seatback assembly RH.
5. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Connect the rear center seat outer belt assembly as shown in the illustration. |
|
6. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
(a) Install the rear seat center headrest assembly.
7. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)
(a) Install the rear seat headrest assembly.
8. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)
(a) Install the rear seat headrest assembly.
Toyota CH-R Service Manual > Tire Pressure Warning System: Registration
REGISTRATION
PROCEDURE
1. BEFORE REGISTRATION
NOTICE:
The transmitter ID is written on the tire pressure warning valve and transmitter.
It is not possible to read the transmitter ID after installing the tire onto the
wheel. Therefore, make a note of the transmitter ID before installing the t ...
Toyota CH-R Service Manual > Wiper And Washer System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the table. Check each symptom by
check ...