Toyota CH-R Service Manual: Fail-safe Chart
FAIL-SAFE CHART
AUTOMATIC HIGH BEAM SYSTEM
(a) The main body ECU (multiplex network body ECU) operates in fail-safe mode if an abnormal condition such as those listed below has been detected.
|
Item |
Abnormality Detection Condition |
Return Condition |
Warning (Multi-information Display) |
|---|---|---|---|
|
Yaw Rate Signal Malfunction |
Normal yaw rate signal is not detected. |
Normal yaw rate signal is detected. |
"Headlight System Malfunction Visit Your Dealer" displayed |
|
Speed Sensor Signal Malfunction |
Normal speed sensor signal is not detected. |
Normal speed sensor signal is detected. |
"Headlight System Malfunction Visit Your Dealer" displayed |
|
CAN Communication System Malfunction |
Normal CAN communication system is not detected. |
Normal CAN communication system is detected. |
"Headlight System Malfunction Visit Your Dealer" displayed |
|
Forward Recognition Camera Signal Malfunction |
Normal forward recognition camera signal is not detected. |
Normal forward recognition camera signal is detected. |
"Headlight System Malfunction Visit Your Dealer" displayed |
Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when decidi ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Automatic High Beam System
DTC No.
Detection Item
Link
B124B
Automatic High Beam System
...
Other materials:
Toyota CH-R Service Manual > Airbag System: Occupant Classification System Malfunction (B1650/32,B165A/32)
DESCRIPTION
The airbag sensor assembly and occupant detection ECU communicate via CAN communication.
When the occupant detection ECU stores DTC B1771, B1780, B1782, B1795, B1798,
B1799, U0125 or U0129, the airbag sensor assembly receives this information and
stores DTC B1650/32.
When the occu ...
Toyota CH-R Service Manual > Front Evaporator Temperature Sensor(for Valeo Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
the No. 1 cooler thermistor removal/installation are shown below.
Necessary Procedure After Parts ...
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
0.011