COMPONENTS
ILLUSTRATION
*1 |
GENERATOR ASSEMBLY |
*2 |
TERMINAL CAP |
*3 |
WIRE HARNESS CLAMP BRACKET |
- |
- |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
*1 |
GENERATOR BRUSH HOLDER ASSEMBLY |
*2 |
GENERATOR COIL ASSEMBLY |
*3 |
GENERATOR DRIVE END FRAME BEARING |
*4 |
GENERATOR PULLEY CAP |
*5 |
GENERATOR PULLEY WITH CLUTCH |
*6 |
GENERATOR REAR END COVER |
*7 |
GENERATOR ROTOR ASSEMBLY |
*8 |
GENERATOR TERMINAL INSULATOR |
*9 |
BEARING COVER PACKING |
*10 |
GENERATOR DRIVE END FRAME |
*11 |
RETAINER PLATE |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
* |
For use with SST |
● |
Non-reusable part |
- |
- |
Toyota CH-R Service Manual > Black Out Tape(for Rear Door): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
the black out tape removal/installation are shown below.
Necessary Procedure After Parts Removed ...
Toyota CH-R Service Manual > Shift Lever: Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY
(a) Disengage the 4 guides and 6 claws to remove the shifting hole cover
sub-assembly from the upper console panel sub-assembly.
2. REMOVE SHIFT POSITION INDICATOR
...