DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
(a) Remove the brake vacuum check valve assembly from the brake booster assembly.
(b) Remove the check valve grommet from the brake booster assembly.
2. REMOVE VACUUM WARNING SWITCH ASSEMBLY
(a) Remove the vacuum warning switch assembly from the brake booster assembly.
(b) Remove the check valve grommet from the brake booster assembly.
Toyota CH-R Service Manual > Vehicle Stability Control System: Open or Short in Brake Pedal Load Sensing Switch (C1429)
DESCRIPTION
The brake pedal load sensing switch turns on when the brake pedal is depressed
with a force exceeding a predetermined level.
The skid control ECU uses this circuit to detect if the brake pedal is depressed
or not.
DTC No.
Detection Item
DTC Detecti ...
Toyota CH-R Service Manual > Power Steering System: Terminals Of Ecu
TERMINALS OF ECU
CHECK POWER STEERING ECU ASSEMBLY
*a
Component without harness connected
(Power Steering ECU Assembly)
-
-
(a) Measure the voltage and resistance according to the value(s) in the table
below.
NOTICE:
When the EPS warni ...