Opening the fuel tank cap
Perform the following steps to open the fuel tank cap:
Before refueling the vehicle
■Fuel types
■Fuel tank opening for unleaded gasoline To help prevent incorrect fueling, your vehicle has a fuel tank opening that only accommodates the special nozzle on unleaded fuel pumps.
■When refueling the vehicle Observe the following precautions while refueling the vehicle. Failure to do so may result in death or serious injury.
A whooshing sound may be heard when the fuel tank cap is loosened.
Wait until the sound cannot be heard before fully removing the cap. In hot weather, pressurized fuel may spray out the filler neck and cause injury.
Fuel contains substances that are harmful if inhaled.
Doing so may cause the fuel to ignite and cause a fire.
This may cause static electricity to build up, resulting in a possible ignition hazard.
■When refueling Observe the following precautions to prevent fuel overflowing from the fuel tank:
■Refueling Do not spill fuel during refueling.
Doing so may damage the vehicle, such as causing the emission control system to operate abnormally, or damaging fuel system components, or the vehicle's painted surface.
Opening the fuel tank cap
1. Press the opener to open the fuel filler door.
2. Turn the fuel tank cap slowly to remove it and hang it on the back of the fuel filler door.
■When the fuel filler door cannot be opened
1. Open the back door and remove the cover underneath the luggage compartment light.
2. Pull the lever backward and check that the fuel filler door opens.
Closing the fuel tank cap
After refueling, turn the fuel tank cap until you hear a click. Once the cap is released, it will turn slightly in the opposite direction.
■When replacing the fuel tank cap Do not use anything but a genuine Toyota fuel tank cap designed for your vehicle. Doing so may cause a fire or other incident which may result in death or serious injury.
Toyota CH-R Service Manual > Rear Door Outside Moulding: Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR DOOR UPPER OUTSIDE MOULDING PAD
(a) Remove the rear door upper outside moulding pad.
...
Toyota CH-R Service Manual > Occupant Classification System: System Description
SYSTEM DESCRIPTION
GENERAL
(a) The occupant detection ECU estimates the weight of an occupant based on signals
received from the 2 occupant classification sensors. The occupant detection ECU
determines whether the front passenger seat is occupied and classifies the occupant
based on the esti ...