PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
Link |
---|---|---|
When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is not black) |
Proceed to "Reverse Signal Circuit"*1 |
|
Proceed to "Reverse Signal Circuit"*2 |
|
|
Proceed to "Image from Camera for Rear View Monitor is Abnormal" |
|
|
Radio and display receiver assembly |
|
|
When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is black) |
Proceed to "Image from Camera for Rear View Monitor is Abnormal" |
|
Radio and display receiver assembly |
|
|
When the shift lever is not in R, an image of the area behind the vehicle is displayed |
Proceed to "Reverse Signal Circuit"*1 |
|
Proceed to "Reverse Signal Circuit"*2 |
|
|
Radio and display receiver assembly |
|
Symptom |
Suspected Area |
Link |
---|---|---|
Rear view monitor display malfunction (distortion of the color/ screen) occurs continuously |
Proceed to "Image from Camera for Rear View Monitor is Abnormal" |
|
Radio and display receiver assembly |
|
|
Rear view monitor display malfunction (distortion of the color/ screen) occurs temporarily |
Check the usage conditions (explain to the customer that the display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver) |
- |
When an image of the area behind the vehicle is displayed, the lines are misaligned (the image from the camera is tilted) |
Check that the camera is correctly installed |
|
Guide lines are not displayed |
Rear television camera assembly |
|
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Unmatched Key Code (B2795)
DESCRIPTION
This DTC is stored when a key with a different vehicle serial number is inserted
into the ignition key cylinder.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
B2795
Unmatched Key Cod ...
Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
blower unit removal/installation are shown below.
Necessary Procedure After Parts Removed/Insta ...