SYSTEM DESCRIPTION
SYSTEM FUNCTION
Function |
Outline |
---|---|
Push-button start function |
When the electrical key transmitter sub-assembly is brought into the vehicle and verified, this function changes the power source or starts the engine when the engine switch and brake pedal are operated. HINT: If an emergency stop was performed (the engine switch was pressed quickly three times or more, or pressed and held for 2 seconds or more) while driving, the engine can be started again if driving at more than 5 km/h, by moving the shift lever to N, and pressing the engine switch. |
Transmitter battery saving function for key |
If a switch on the electrical key transmitter sub-assembly is depressed and held, this function stops transmission of the signal after approximately 20 seconds to save transmitter battery power. |
Transmitter battery saving mode function |
|
Key cancel function |
Cancels the smart key system when certain operations are performed. |
Immobiliser function |
Allows the engine to be started only by registered electrical key transmitter sub-assemblies to prevent an unauthorized engine start. |
Automatic power off function |
|
DETECTION AREA
NOTICE:
(a) The vehicle interior detection area is formed and the electrical key transmitter sub-assembly is detected when any of the following conditions are met: 1) The driver door is opened and closed, 2) the brake pedal is depressed, 3) the engine switch is operated, 4) the conditions required for various warnings are met, or 5) an entry door lock operation is performed.
(b) The vehicle interior detection area when starting the engine can be customized through a customize setting.
Click here
Toyota CH-R Service Manual > Lighting (ext): Rear Light Assembly(for Led Type)
Components
COMPONENTS
ILLUSTRATION
*1
REAR LIGHT ASSEMBLY
*2
REAR LIGHT PACKING
●
Non-reusable part
-
-
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure ...
Toyota CH-R Service Manual > Navigation System: USB Audio System Recognition/Play Error
DESCRIPTION
When a USB device or "iPod" is connected to the USB jack of the stereo jack adapter
assembly, it must have playable files. The device must also communicate with and
be recognized by the radio and display receiver assembly. This diagnostic procedure
is for when a device i ...