Toyota CH-R Service Manual: On-vehicle Inspection

• Cuts on the surface or in the grooves
• Small cracks on the surface or in the grooves
• Significant discoloration on the surface or in the grooves

• Cuts on the surface or in the grooves
• Small cracks on the surface or in the grooves
• Significant discoloration on the surface or in the grooves
• Cracks or other damage to the connector
• Deformation of the steering wheel assembly
• Deformation of the installation surface of the horn button assembly
• Interference or uneven clearance between the horn button assembly and steering wheel assembly when a new horn button assembly is installed to the steering wheel assembly

Components

COMPONENTS ILLUSTRATION *1 HORN BUTTON ASSEMBLY - - ...

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

Other materials:

Toyota CH-R Service Manual > Brake Booster: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check (1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times. If the pedal can be depressed nearly to the floor the first time, but on the 2nd and ...

Toyota CH-R Service Manual > Pre-collision System: Front Camera Module Incorrect Axial Gap (C1AA8,C1AA9)
DESCRIPTION If the millimeter wave radar sensor assembly detects that the forward recognition camera beam has an axis misalignment, DTC C1AA8 is output. Also if forward recognition axis adjustment has not been performed or did not complete normally after the forward recognition camera was repl ...