Toyota CH-R Service Manual: Seat Belt Warning Light

Toyota CH-R Service Manual / Seat Belt / Seat Belt Warning Light

Components

COMPONENTS

ILLUSTRATION

CLOCK ASSEMBLY

INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY

Removal

REMOVAL

CAUTION / NOTICE / HINT

Click here

Inspection

INSPECTION

PROCEDURE

1. INSPECT SEAT BELT WARNING LIGHT (CLOCK ASSEMBLY)

(a) Check illumination.

(1) Apply battery voltage to the seat belt warning light (clock assembly) and check that it illuminates.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1 (IG+)

Battery negative (-) → Terminal 12 (RLID)

LH light illuminates

Battery positive (+) → Terminal 1 (IG+)

Battery negative (-) → Terminal 13 (RCID)

Center light illuminates

Battery positive (+) → Terminal 1 (IG+)

Battery negative (-) → Terminal 14 (RRID)

RH light illuminates

If the result is not as specified, replace the seat belt warning light (clock assembly).

*a	Component without harness connected (Seat Belt Warning Light (Clock Assembly))
*b	LH Light
*c	Center Light
*d	RH Light

Disposal

DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre ...

Seat Belt Warning System(w/ Occupant Classification System)

...

Other materials:

Toyota CH-R Owners Manual > Engine compartment: Brake fluid
■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reserv ...

Toyota CH-R Service Manual > Blind Spot Monitor System: Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH (Slave) detects a short to ground in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB3 Short to GN ...