COMPONENTS
ILLUSTRATION
*1 |
FRONT SEAT CUSHION SHIELD |
*2 |
FRONT SEAT INNER BELT ASSEMBLY |
*3 |
FRONT SEAT INNER CUSHION SHIELD |
*4 |
RECLINING ADJUSTER RELEASE HANDLE |
*5 |
RECLINING HINGE OUTER COVER |
*6 |
FRONT SEAT BELT ANCHOR PLATE |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
*1 |
SEPARATE TYPE FRONT SEATBACK ASSEMBLY |
- |
- |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
*1 |
SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
- |
- |
ILLUSTRATION
*1 |
OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD) |
*2 |
SEPARATE TYPE FRONT SEAT CUSHION COVER |
Toyota CH-R Service Manual > Can Communication System: Check Bus 3 Line for Short to +B
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and +B when no
resistance exists between terminal 6 (CA3H) of the central gateway ECU (network
gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the central
gateway ECU (network gateway ECU) and t ...
Toyota CH-R Service Manual > Rear Door Speaker: Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ...