Replacement
REPLACEMENT
PROCEDURE
1. REMOVE NO. 1 MAP LIGHT LENS
Click here
2. REMOVE MAP LIGHT BULB
(a) Remove the 2 map light bulbs as shown in the illustration.
Remove in this Direction |
3. INSTALL MAP LIGHT BULB
(a) Install the 2 map light bulbs as shown in the illustration.
Install in this Direction |
4. INSTALL NO. 1 MAP LIGHT LENS
Click here
Toyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the J6 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector ...
Toyota CH-R Service Manual > Safety Connect System: Green And Red Indicators Do Not Come On When Ig-on
DESCRIPTION
If the red and green indicators fail to illuminate after the ignition switch
turned to ON, the vehicle does not recognize the DCM (Telematics Transceiver). The
DCM (Telematics Transceiver) connectors may have been disconnected or the DCM (Telematics
Transceiver) is malfunctioning. ...