Toyota CH-R Service Manual: Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Take extra care when handling these precision electronic components.
PROCEDURE
1. REMOVE TRANSMITTER BATTERY
(a) Slide the release hook knob to remove the mechanical key as shown in the illustration.
.png)
|
*a |
Hook Knob |
.png) |
Remove in this Direction |
|
(b) Using a screwdriver with its tip wrapped in protective tape, remove the transmitter housing cover as shown in the illustration. NOTICE: Do not use excessive force when prying apart the transmitter housing cover. |
|
.png)
(c) Using a screwdriver with its tip wrapped in protective tape, remove the transmitter battery as shown in the illustration.
NOTICE:
- Do not push the terminals with your finger.
- Do not forcibly pry up the transmitter battery as the terminals may be damaged.
- Do not touch the transmitter battery with wet hands. Moisture may cause rust.
- Do not touch or move any components inside the transmitter housing case. It may interfere with proper operation.
- When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.
.png)
|
*a |
Protective Tape |
|
|
Remove in this Direction |
Components
COMPONENTS
ILLUSTRATION
*1
TRANSMITTER BATTERY
*2
MECHANICAL KEY
*3
TRANSMITTER HOUSING COVER
*4
TRANS ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY
(a) Inspect the operation of the electrical key transmitter sub-assembly.
(1) Remove the transmitter battery from the electr ...
Other materials:
Toyota CH-R Service Manual > Meter / Gauge System: Washer Fluid Level Warning Switch Circuit
DESCRIPTION
The combination meter assembly and level warning switch assembly are connected
via direct line. The combination meter assembly determines the washer fluid level
and outputs warning messages according to the washer fluid level warning switch
ON/OFF signal.
WIRING DIAGRAM
CAUTIO ...
Toyota CH-R Service Manual > Wiper And Washer System: Operation Check
OPERATION CHECK
FRONT WIPER MOTOR AND LINK ASSEMBLY INSPECTION
(a) AUTO Wiper Inspection (w/ Rain Sensor)
(1) Continuously apply water to the windshield glass in front of the rain sensor.
(2) Turn the ignition switch to ON.
(3) Move the windshield wiper switch assembly to the AUTO position.
(4 ...
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
0.0113