Toyota CH-R Service Manual: Precaution

NOTICE:

• The power window control system uses the LIN communication system and CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

  Click here

• The power window control system prohibits the auto up and down functions if the jam protection function or catch protection function malfunctions.
• If a power window regulator motor assembly has been replaced with a new one, initialize a power window control system.

  Click here

• If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

  Click here

• The jam protection function or catch protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
  1. A power window is being opened or closed while the vehicle is driven on a rough road.
  2. A power window is being opened or closed while the door is being opened or closed.
  3. The voltage changes abruptly.
• Do not disconnect the battery while the ignition switch is ON. Otherwise, DTC B2313 will be stored.

  Click here

Power Window Control System

...

Parts Location

PARTS LOCATION ILLUSTRATION *A w/ Smart Key System - - *1 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *2 ...

Other materials:

Toyota CH-R Service Manual > Knee Airbag Assembly: Components
COMPONENTS ILLUSTRATION *A for TMMT Made *B for TMC Made *1 INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY *2 INSTRUMENT PANEL LOWER CENTER FINISH PANEL *3 LOWER NO. 1 INST ...

Toyota CH-R Service Manual > Rear Wiper Motor: Installation
INSTALLATION PROCEDURE 1. INSTALL REAR WIPER MOTOR ASSEMBLY (a) Install the rear wiper motor assembly with the 3 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (b) Connect the connector. 2. INSTALL REAR WIPER MOTOR GROMMET (a) Apply MP grease to the entire surface of the rear w ...