PARTS LOCATION
ILLUSTRATION
*A |
for LED Headlight |
*B |
w/ Fog Light |
*C |
w/ Door Mirror Foot Light |
- |
- |
*1 |
FOG LIGHT ASSEMBLY RH |
*2 |
FOG LIGHT ASSEMBLY LH |
*3 |
HEADLIGHT UNIT ASSEMBLY RH |
*4 |
HEADLIGHT UNIT ASSEMBLY LH |
*5 |
HEADLIGHT ECU SUB-ASSEMBLY RH |
*6 |
HEADLIGHT ECU SUB-ASSEMBLY LH |
*7 |
SIDE TURN SIGNAL LIGHT ASSEMBLY RH |
*8 |
SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
*9 |
DOOR MIRROR FOOT LIGHT RH |
*10 |
DOOR MIRROR FOOT LIGHT LH |
ILLUSTRATION
*A |
for Halogen Headlight |
- |
- |
*1 |
PARK/NEUTRAL POSITION SWITCH |
*2 |
NO. 1 INTEGRATION RELAY - H-LP RH RELAY - H-LP LH RELAY |
*3 |
P-CON RELAY |
*4 |
NO. 1 ENGINE ROOM RELAY BLOCK - H-LP RH FUSE - H-LP LH FUSE |
*5 |
H-LP SHADE FUSE |
*6 |
DRL FUSE |
*7 |
H-LP SHADE RELAY |
- |
- |
ILLUSTRATION
*A |
w/ Fog Light |
- |
- |
*1 |
AUTOMATIC LIGHT CONTROL SENSOR |
*2 |
HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
*3 |
HEADLIGHT DIMMER SWITCH ASSEMBLY |
*4 |
STOP LIGHT SWITCH ASSEMBLY |
*5 |
FR FOG RELAY |
*6 |
COMBINATION METER ASSEMBLY |
*7 |
DLC3 |
*8 |
MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
*9 |
NO. 9 RELAY BLOCK ASSEMBLY |
*10 |
INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ACC RELAY - IG1-NO. 1 RELAY - TAIL RELAY - ECU-DCC NO. 2 FUSE - ECU ACC FUSE - TAIL FUSE - ECU-IG1 NO. 4 FUSE - ECU-IG1 NO. 3 FUSE - METER-IG2 FUSE - HAZ FUSE - STOP FUSE - BKUP LP FUSE - BKUP LP RELAY |
ILLUSTRATION
*1 |
CENTER STOP LIGHT ASSEMBLY |
*2 |
LICENSE PLATE LIGHT ASSEMBLY RH |
*3 |
LICENSE PLATE LIGHT ASSEMBLY LH |
*4 |
REAR COMBINATION LIGHT ASSEMBLY RH |
*5 |
REAR COMBINATION LIGHT ASSEMBLY LH |
*6 |
REAR LIGHT ASSEMBLY RH |
*7 |
REAR LIGHT ASSEMBLY LH |
- |
- |
Toyota CH-R Service Manual > Knee Airbag Assembly: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
lower No. 1 instrument panel airbag assembly removal/installation are shown below.
Necessary Pr ...
Toyota CH-R Service Manual > Back Door Courtesy Switch: Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK DOOR LOCK ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
...