Toyota CH-R Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Click here

2. REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY

Click here

3. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY

Click here

4. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Disengage the claws to remove the hazard warning signal switch assembly.

    Components
    COMPONENTS ILLUSTRATION *1 HAZARD WARNING SIGNAL SWITCH ASSEMBLY *2 INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY *3 ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resi ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Brake Warning Light does not Come ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning. Click here ...

    Toyota CH-R Service Manual > Black Out Tape(for Rear Door): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REPAIR INSTRUCTION Click here 2. INSTALL REAR DOOR OUTSIDE STRIPE (a) Refer to the illustration to position a new rear ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2024 Copyright www.tochr.net
    0.0115