DISASSEMBLY
PROCEDURE
1. REMOVE NO. 2 REAR SPOILER
(a) Remove the 2 screws.
![]() |
Remove in this Direction |
(b) Disengage the claws to remove the No. 2 rear spoiler as shown in the illustration.
2. REMOVE NO. 2 REAR SPOILER PROTECTOR
HINT:
Using the same procedure, remove every No. 2 rear spoiler protector.
(a) Remove the No. 2 rear spoiler protector. |
|
3. REMOVE CENTER STOP LIGHT ASSEMBLY
Click here
4. REMOVE REAR SIDE SPOILER SUB-ASSEMBLY
(a) Disengage the claws and guide to remove the rear side spoiler sub-assembly as shown in the illustration.
![]() |
Remove in this Direction |
(b) Remove the screw. |
|
(c) Disengage the guide to remove the No. 5 rear spoiler retainer.
5. REMOVE CENTER STOP LIGHT CORD ASSEMBLY
(a) Disengage the guides to remove the center stop light cord assembly. |
|
6. REMOVE NO. 1 REAR SPOILER PROTECTOR
HINT:
Using the same procedure, remove every No. 1 rear spoiler protector.
(a) Remove the No. 1 rear spoiler protector. |
|
Toyota CH-R Service Manual > Lin Communication System: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Swi ...
Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Reverse Signal Circuit
DESCRIPTION
The radio and display receiver assembly receives a reverse signal from the park/neutral
position switch.
WIRING DIAGRAM
PROCEDURE
1.
CHECK BACK-UP LIGHT
(a) Move the shift lever to R and check if the back-up lights come on.
OK:
The back-up ligh ...