Toyota CH-R Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE REAR DOOR OUTSIDE MOULDING

(a) Apply protective tape around the rear door outside moulding.

Protective Tape

(b) Remove the hole cover.

(c) Remove the nut and gasket.

(d) Disengage the clips to remove the rear door outside moulding as shown in the illustration.

Remove in this Direction

    Components
    COMPONENTS ILLUSTRATION *1 REAR DOOR OUTSIDE MOULDING *2 HOLE COVER *3 GASKET - - ILLUSTRATI ...

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR DOOR UPPER OUTS ...

    Other materials:

    Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Telematics Transceiver Disconnected (B15DB)
    DESCRIPTION If the radio and display receiver assembly cannot detect the DCM (telematics transceiver) for a certain period of time (90 seconds) after the ignition switch is turned on (ACC) and the radio and display receiver assembly confirms that the information is missing by checking past DC ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Output Value (C1448)
    DESCRIPTION The yaw rate and acceleration sensor is built into the airbag sensor assembly. The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor a ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0114