COMPONENTS
ILLUSTRATION
*1 |
REAR DOOR BELT REAR SEAL |
*2 |
REAR DOOR BELT SEAL |
*3 |
REAR DOOR GLASS INNER WEATHERSTRIP |
*4 |
REAR DOOR INSIDE HANDLE BEZEL PLUG |
*5 |
REAR DOOR INSIDE HANDLE SUB-ASSEMBLY |
*6 |
REAR DOOR REAR FRAME BRACKET |
*7 |
REAR DOOR TRIM BOARD SUB-ASSEMBLY |
*8 |
REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL |
ILLUSTRATION
*A |
w/ Rear Seat Side Airbag |
- |
- |
*1 |
NO. 2 REAR DOOR FRAME GARNISH |
*2 |
NO. 2 SEPARATOR DOOR STIFFENER CUSHION |
*3 |
REAR DOOR BELT MOULDING ASSEMBLY |
*4 |
REAR DOOR CUSHION |
*5 |
REAR DOOR FRAME GARNISH |
*6 |
REAR DOOR GLASS RUN |
*7 |
REAR DOOR GLASS SUB-ASSEMBLY |
*8 |
REAR DOOR INSIDE PANEL REINFORCE SUB-ASSEMBLY |
*9 |
REAR DOOR SERVICE HOLE COVER |
*10 |
REAR DOOR TRIM BRACKET |
*11 |
REAR DOOR WINDOW REGULATOR ASSEMBLY |
*12 |
BUTYL TAPE |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
MP grease |
- |
- |
ILLUSTRATION
*1 |
REAR DOOR LOCK WITH MOTOR ASSEMBLY |
*2 |
REAR DOOR OUTSIDE HANDLE ASSEMBLY |
*3 |
REAR DOOR OUTSIDE HANDLE COVER |
*4 |
REAR DOOR OUTSIDE HANDLE SEAL |
*5 |
REAR DOOR QUARTER WINDOW GLASS |
*6 |
REAR DOOR QUARTER WINDOW WEATHERSTRIP |
*7 |
REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY |
*8 |
DOOR LOCK WIRING HARNESS SEAL |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
MP grease |
- |
- |
ILLUSTRATION
*1 |
HOLE PLUG |
*2 |
REAR DOOR CHECK ASSEMBLY |
*3 |
REAR DOOR DUST PROOF SEAL |
*4 |
REAR DOOR OUTSIDE MOULDING |
*5 |
REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
*6 |
REAR DOOR PANEL CUSHION |
*7 |
REAR DOOR WEATHERSTRIP |
*8 |
REAR SPEAKER ASSEMBLY |
*9 |
RIVET |
*10 |
GASKET |
*11 |
HOLE COVER |
- |
- |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
MP grease |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
||
★ |
Precoated part |
- |
- |
ILLUSTRATION
*1 |
REAR DOOR LOWER OUTSIDE STRIPE |
*2 |
REAR DOOR OUTSIDE STRIPE |
*3 |
REAR DOOR REAR WINDOW FRAME MOULDING |
*4 |
REAR DOOR UPPER WINDOW FRAME MOULDING |
*5 |
RIVET |
- |
- |
● |
Non-reusable part |
- |
- |
Toyota CH-R Service Manual > Rear Wiper Rubber: Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WIPER BLADE
(a) Lift the rear wiper arm and blade assembly as shown in the illustration.
(b) Raise the rear wiper blade to the position where the claw disengages
with a click sound as shown ...
Toyota CH-R Service Manual > Lumbar Switch: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
front lumbar power seat switch removal/installation are shown below.
Necessary Procedure After ...