Toyota CH-R Service Manual: Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY

(a) Extend the piston rod and secure the rear shock absorber assembly at an angle in a vise.

(b) Using a hacksaw, slowly make a hole at the position indicated by the arrow in the illustration to discharge the gas inside.

CAUTION:

  • Always use a cloth to prevent shards of metal flying about due to the release of pressurized gas.
  • Always wear safety glasses.

HINT:

The gas is colorless, odorless and non-poisonous.

    Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR SHOCK ABSORBER ASSEMBLY (a) Compress and extend the rear shock absorber assembly rod 4 or more times. Standard: When compressed and extended at a constant sp ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR SUSPENSION S ...

    Other materials:

    Toyota CH-R Service Manual > Key Reminder Warning System: Terminals Of Ecu
    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY *A Main Body ECU (Multiplex Network Body ECU) with 2 Connectors - - *1 Main Body ECU (Multiplex Network Body EC ...

    Toyota CH-R Service Manual > Pre-collision System: Utility
    UTILITY NOTICE: When replacing a millimeter wave radar sensor assembly, replace it with a new one. If the millimeter wave radar sensor assembly has been replaced or removed/installed, be sure to perform Front Beam Axis Adjustment. If not performed, DTC C1A14 will be stored when the system i ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0116