Toyota CH-R Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Check for DTCs, and then write them down.

Powertrain > Engine and ECT > Trouble Codes

(f) Check the details of the DTCs.

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Clear DTCs.

(e) Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
    Diagnosis System
    DIAGNOSIS SYSTEM DLC3 (Data Link Connector 3) (a) Check the DLC3. Click here BATTERY VOLTAGE Standard Voltage: 11 to 14 V If the voltage is below 11 V, replace or recharge the battery. ...

    Freeze Frame Data
    FREEZE FRAME DATA DESCRIPTION The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in ...

    Other materials:

    Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
    DESCRIPTION If the key ID codes of the key and transponder key ECU assembly match, the immobiliser system is unset and the engine start permission signal is sent to the ECM. When the ID codes of the transponder key ECU assembly and ECM match, the engine starts. WIRING DIAGRAM CAUTION / NOTI ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: ABS Operates Before Necessary When Braking
    DESCRIPTION Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc. PROCEDURE 1. PERFORM TEST MODE (SIGNAL CHECK) INSPECTION (SPEED SENSOR CIRCUIT) (a) Using the Techstream, perform a Test Mode (Si ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2024 Copyright www.tochr.net
    0.0094