CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio receiver assembly, even if the portable audio player itself can play files.
Click here
PROCEDURE
1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
Result |
Proceed to |
---|---|
The portable player is "Bluetooth" audio compatible. |
A |
The portable player is not "Bluetooth" audio compatible. |
B |
B |
USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to Owner's Manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
HINT:
The portable player cannot be registered under any of the following conditions:
OK:
The portable player has been registered as a connected device.
OK |
END |
|
3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
NG |
MALFUNCTION IN PORTABLE PLAYER |
|
4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the radio receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
OK |
END |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Toyota CH-R Service Manual > Lin Communication System: LIN Communication Bus Malfunction (B2325)
DESCRIPTION
If the main body ECU (multiplex network body ECU) detects a communication error
with an ECU connected to the door bus lines for 7 seconds or more, DTC B2325 will
be stored.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
...
Toyota CH-R Service Manual > How To Troubleshoot Ecu Controlled Systems: Electronic Circuit Inspection Procedure
ELECTRONIC CIRCUIT INSPECTION PROCEDURE
BASIC INSPECTION
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance measurements are standard values
measured at an ambient temperature of 20°C (68°F). Resistance measurements may be
inaccurate if measured at ...