Toyota CH-R Service Manual: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

Toyota CH-R Service Manual / Audio / Video / Audio And Visual System(for Radio Receiver Type) / Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.

CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END
NG

2.

CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END
NG

3.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

MALFUNCTION IN PORTABLE PLAYER
    Cellular Phone Inspection
    CAUTION / NOTICE / HINT HINT: If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation. PROCEDURE ...

    Does not Play even after Bluetooth Audio Mode is Selected
    CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

    Other materials:

    Toyota CH-R Service Manual > Blind Spot Monitor System: Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the blind spot monitor system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Code ...

    Toyota CH-R Service Manual > Pre-collision System: Utility
    UTILITY NOTICE: When replacing a millimeter wave radar sensor assembly, replace it with a new one. If the millimeter wave radar sensor assembly has been replaced or removed/installed, be sure to perform Front Beam Axis Adjustment. If not performed, DTC C1A14 will be stored when the system i ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2024 Copyright www.tochr.net
    0.0094