Toyota CH-R Service Manual: System Diagram

SYSTEM DIAGRAM

Communication Table

Transmitting ECU

(Transmitter)

Receiving ECU

Signal

Communication Method

Airbag Sensor Assembly

ECM

  • Crash detection signal

CAN

Airbag Sensor Assembly

Combination Meter Assembly

  • SRS warning light on demand signal
  • Diagnosis signal (DTC)

Airbag Sensor Assembly

Skid Control ECU (Brake Actuator Assembly)

  • Yaw rate and acceleration signal

Occupant Detection ECU*

Airbag Sensor Assembly

  • Occupant classification system failure signal
  • Occupant classification system zero point error signal
  • Occupant state for passenger signal
  • Buckle switch state of passenger signal

ECM

Airbag Sensor Assembly

  • Shift position signal
  • Test mode signal
  • Engine speed signal

Skid Control ECU (Brake Actuator Assembly)

Airbag Sensor Assembly

  • Vehicle speed signal
  • Stop signal

Main Body ECU (Multiplex Network Body ECU)

Airbag Sensor Assembly

  • Trip count signal
  • Time count signal

*: w/ Occupant Classification System

    Parts Location
    PARTS LOCATION ILLUSTRATION *1 FRONT AIRBAG SENSOR LH *2 FRONT AIRBAG SENSOR RH *3 DOOR SIDE AIRBAG SENSOR LH *4 ...

    System Description
    SYSTEM DESCRIPTION GENERAL (a) Acceleration sensors and pressure sensors used for the airbag system are installed to various parts on the vehicle and calculate the acceleration rate and pressure ...

    Other materials:

    Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Pressure Sensor Circuit (B1423)
    DESCRIPTION This DTC is stored if refrigerant pressure on the high pressure side is extremely low (195 kPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (2812 kPa (28.7 kgf/cm2, 408 psi) or more). The air conditioner pressure (2 words) sensor, which is installed to the high pressure side p ...

    Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Back-up Power Source Circuit
    DESCRIPTION The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the ignition switch is off. This power is used for diagnostic trouble code memory, etc. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2024 Copyright www.tochr.net
    0.0206